Hydrex Performs Collision Damage Repair (Greece)

In July Hydrex mobilized a team of diver/technicians to Syros, Greece, for a complex repair operation on an 118-meter, 8550 DWT chemical tanker.

The vessel had suffered large cracks in her hull plating as the result of a collision. She was not allowed to sail any further. Hydrex proposed a permanent on-site repair using an open top cofferdam. This would enable the fully laden ship to continue her journey.

The tanker was berthed in Egypt when another vessel struck her port side hull. This caused a large hole, severe cracks and dented plating. The collision also pushed the vessel’s starboard side hard against the fenders, denting the plating on that side as well.

The owner of the vessel contacted Hydrex to find the best repair solution for the vessel. Because it was fully laden, going into drydock was not feasible. An on-site underwater solution was needed.

In consultation with Hydrex, the ship’s owner opted to take his vessel to the Ncorion Syros Shipyards, situated on the island of Syros in Greece. When the ship arrived, the classification society decided that the damage to the portside hull plating was too severe to let the tanker sail any further.

Hydrex Performs Collision Damage Repair (Greece)

The vessel berthed in the yard, allowing for a close cooperation between Hydrex and Ncorion during the entire operation.

“After arriving on-site we first performed a detailed underwater inspection of the damage,” the Hydrex team leader says. “We used the information we collected to come up with the best possible option for the repair. This was done in communication with the technical department at the Hydrex headquarters.”

A permanent repair would be performed to the extensive damage to the portside plating. The less severe damage to the starboard side plating would be temporarily repaired. This would allow the tanker to sail to Hamburg, unload her cargo and then quickly drydock for a permanent repair to the starboard side plating.

The damaged area on the portside would be closed off with an open top cofferdam. This allowed the Hydrex team to create a dry environment in which the shipyard could perform permanent repairs in drydock-like conditions.

Hydrex Performs Collision Damage Repair (Greece)

“Using a special frame, exact measurements were made of the area that needed to be covered,” the team leader explains. “With these measurements a custom cofferdam was designed by the Hydrex technical department. The cofferdam was then constructed by the shipyard.”

Once the open top cofferdam was ready, the Hydrex team installed it over the damaged hull plating in no more than two hours. All water was removed from inside the cofferdam. The yard then replaced the dented shell plating. The affected web frames were also replaced, using templates from the starboard side frames.

While the yard was performing the insert repair, the Hydrex diver/technicians installed temporary stiffeners over outside of the dented starboard side plating.

“The reason they could not renew the damaged frames on this side was because the cargo could not be shifted,” tells Andrew Anagnostis, Business Manager at Neorion Syros Shipyards. “The temperature was around 70° on the bulkhead and about 45-50° in the other areas. So it was impossible for anybody to do any work, let alone weld.”

Hydrex Performs Collision Damage Repair (Greece)

The repairs to both sides of the vessel were approved by the classification society. This allowed the vessel to sail from Syros. The tanker then made her way to Germany where she will be unloaded before paying a quick visit to drydock for permanent repairs to the starboard side hull plating. Because no further attention will be needed for the portside, the visit to drydock can be very short and economical.

“The Hydrex team was very well-organized and we were very pleased. We have never dealt with a similar situation before, carrying out repairs underwater, inside a cofferdam,” says Anagnostis.

“Everything went smoothly. The vessel is owned by a long time customer of ours so we were pleased that we managed to help them out together with Hydrex.”

Press Release, August 11, 2014

 

 

 

 

Share this article

Follow Subsea World News

Events>

<< Nov 2017 >>
MTWTFSS
30 31 1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 1 2 3

Subsea Expo 2018

The largest wholly-focused subsea event in Europe, Subsea Expo is organised by industry body Subsea UK…

read more >

8th Myanmar Oil, Gas & Power Summit

The Myanmar Oil and Gas Summit is the longest established Oil & Gas event in Myanmar. Every year the event is attended by government…

read more >

European Gas Conference 2018

The European Gas Conference celebrated its tenth anniversary amid an air of increasing optimism following considerably shifting markets in the last few years…

read more >

SPE/IADC Middle East Drilling Technology Conference and Exhibition

The theme for this conference is “Building on Today’s Efficiencies for Tomorrow’s Market.” This will be the basis for the technical agenda…

read more >